Checking optical port attenuation parameters of H3C switches
Run the following command to view the Digital Diagnostic Monitoring (DDM) data of the optical module: show transceiver diagnosis interface <interface-type> <interface-number> The output provides real-time diagnostic metrics and their corresponding threshold ranges. Reading optical module information during use helps understand its real-time operating status, allowing you to locate the cause of link abnormalities more quickly. The following uses the Moduletek QSFP-40G-LR4 module connected to an H3C S6820 switch as an example to introduce how to read. System view or Ethernet port view ratio: Specifies the allowed maximum ratio of the broadcast traffic to the total bandwidth on one or each port. General guidelines IMPORTANT: To prevent an issue from causing loss of configuration, save the configuration each time you finish configuring a feature. Today ETU-Link will introduce the matching scheme for H3C S5810 series switch and optical module. Perform basic operations including display, debug, file management, FTP, Telnet, clock setting, and reboot. Add the specified port to the current VLAN Configure the link type of the port as Trunk type Allow the specified VLAN to pass through the current Trunk port Set the default VLAN for the trunk port Configure the link type of the port as Hybrid View the VLANs that exist on the current switch View the.
Read More
