Electromechanical relays can be classified into several different types as follows: "Armature"-type relays have a pivoted lever supported on a hinge or knife-edge pivot, which carries a moving contact. These relays may work on either alternating or direct current, but for alternating current, a shading coil on the pole is used to maintain contact force throughout the alternating current cycle.
Read More
The various protective functions available on a given relay are denoted by standard. For example, a relay including function 51 would be a timed overcurrent protective relay.
Read More
Closing characteristics of the sync check relay are determined by the magnitude of vector difference voltage setting, typically anywhere from 0-80 volts at the relay.
Read More
Subtract the led voltage from the supply voltage, this gives the Voltage across the resistor, and divide it by the led current, that will give you the resistance to use. Optocupler: FAIRCHILD MOCD207M According to the data sheet with If=1mA minimum CTR is 34%. Since a nano will probably fry instantly if the 12v trigger wire is directly connected to it, i used to use a 5v1 Zener diodes coupled with a few resistors to step down voltage to 5v. An optocoupler, also known as photocoupler or opto-isolator, is a device which can transfer an electrical signal across two galvanically-isolated circuits by way of optical coupling. Unlike transformers or capacitors, which can only transfer AC signals across the isolation barrier, optocouplers can.
Read More
The first protective relays were electromagnetic devices, relying on coils operating on moving parts to provide detection of abnormal operating conditions such as over-current,, reverse flow, over-frequency, and under-frequency.
Read More+27 21 850 1234
+34 936 214 587
Avinguda de la Garriga 23, 08830 Sant Boi de Llobregat, Barcelona, Spain